- Újszülött
Szakmai Híd-Egyenirányító MXG(Y)25-15 Forgó Egyenirányító Híd-Egyenirányító Modul az Autóipari Elektronikai
HUF 6736.50
Ez hatékony segítség a generátor, hogy állítsa be a jelenlegi hogy a normál szintre.Elfogadása eredeti behozott dióda, kiváló helyesbítését funkció.Professzionális gyártási, gyönyörű kivitelezés, nagy megbízhatóság.Készült prémium minőségű anyag, egyszerű felépítés, hosszú élettartam.Vadonatúj, jó minőségű, egyenirányító, stabil teljesítményt.Készült prémium minőségű anyag, egyszerű felépítés, hosszú élettartam.Ez hatékony segítség a generátor, hogy állítsa be a jelenlegi hogy a normál szintre.Vadonatúj, jó minőségű, egyenirányító, stabil teljesítményt.Elfogadása eredeti behozott dióda, kiváló helyesbítését funkció.Professzionális gyártási, gyönyörű kivitelezés, nagy megbízhatóság.
Főbb jellemzők
- Condition:
- 100% brand new
- Working temperature:
- - 40℃ to +125℃ (thyristor, rapid thyristor); -40℃ to +150℃ (rectifier tube, fast recovery diode, ultra-fast recovery diode)
- Relative humidity:
- ≤85%
- Altitude:
- below 1000 meters
- Requirements and Suggestions for module installation:
- A) The installation surface of the module shall be smooth without scratches, bumps and sundries; :
- B) When installing the module to the heat sink, gently the oxide layer on the surface of the heat sink with fine sandpaper, wipe the surface of the heat sink with anhydrous ethanol, and then evenly apply a thin layer of heat-conducting silica gel on the contact surface of the copper base plate and the heat sink to make the contact good and reduce the thermal resistance; :
- C) When fastening the module on the heat sink surface, use M5 or M6 flat batten and spring washer, and fasten the screw with (5+1)Nm force distance; :
- D) The wiring of the main electrode of the module shall be copper strip with smooth, flat and sufficient contact surface. The contact must be good. The tightening moment of force shall be:
- If M5 screws are used, the moment of force shall be (3) Nm; If M6 screws are used, the moment of force is (5+1)Nm. If M8 screws are used, the moment of force is (9+1) Nm.
- Package List:
- 1 * MXY25-15 Rectifier Module :
- 1 * MXG25-15 Rectifier Module :
- 1. The environment should be free from violent vibration and impact, and the environment medium should be free from :